TraceWin release 2.25.1.1
https://www.dacm-logiciels.fr/downloads
Search found 1067 matches
- Wed 2 Jul 2025 18:36
- Forum: Announcements
- Topic: TraceWin release 2.25.1.1
- Replies: 0
- Views: 1
- Thu 19 Jun 2025 11:24
- Forum: TraceWin
- Topic: Misalignment effect
- Replies: 1
- Views: 70
Re: Misalignment effect
Dear Sir, Commands of type ERROR_XXX are only used to specify the range of errors. You also need to specify in the interface, on the ‘Errors’ -> ‘Error Setup’ page, which errors you want to apply and for how many runs you want to do. Then, you need to know whether you want to do just one run or stat...
- Wed 18 Jun 2025 12:59
- Forum: TraceWin
- Topic: Dispersion Curves with Gradient Errors [SOLVED]
- Replies: 1
- Views: 43
Re: Dispersion Curves with Gradient Errors [SOLVED]
Dear Abhishek, in the file ""partran1.out" for tracking or "tracewin1.out" for envelope results you can have the dispersion terms at each position of your simualtion File format is describe in the manuel see : https://dacm-codes.fr/Softwares/TraceWin_DOC/tracewin.htm#_Partran_and_Toutatis If you are...
- Fri 13 Jun 2025 15:36
- Forum: TraceWin
- Topic: Parallelization capability for beam-transport optimization [SOLVED]
- Replies: 3
- Views: 105
Re: Parallelization capability for beam-transport optimization [SOLVED]
Dear Pau
It is clear that the parallelization implemented in TraceWin was not at all designed to speed up the optimization phase, but to reduce the calculation time for very high numbers of particles, greater than 10e7.
Regards,
Didier
It is clear that the parallelization implemented in TraceWin was not at all designed to speed up the optimization phase, but to reduce the calculation time for very high numbers of particles, greater than 10e7.
Regards,
Didier
- Fri 13 Jun 2025 15:02
- Forum: TraceWin
- Topic: Parallelization capability for beam-transport optimization [SOLVED]
- Replies: 3
- Views: 105
Re: Parallelization capability for beam-transport optimization [SOLVED]
Dear Pau, Typically, during a tracking optimization, TraceWin will by default use 1000 particles and with this number going beyond 4 cores would be counter-productive in terms of efficiency (due to openMP). Now TraceWin can perfectly well be used in bath mode and there if your own optimisation algor...
- Thu 12 Jun 2025 16:50
- Forum: Announcements
- Topic: TraceWin release 2.25.1.0
- Replies: 0
- Views: 69
- Wed 11 Jun 2025 10:59
- Forum: Announcements
- Topic: GenDTL release 6.3.0.3
- Replies: 0
- Views: 36
- Wed 11 Jun 2025 10:59
- Forum: Announcements
- Topic: GenLinWin release 3.1.0.5
- Replies: 0
- Views: 35
- Wed 11 Jun 2025 10:58
- Forum: Announcements
- Topic: TraceWin release 2.25.0.3
- Replies: 0
- Views: 36
- Wed 11 Jun 2025 10:58
- Forum: Announcements
- Topic: PlotWin release 4.10.0.5
- Replies: 0
- Views: 29