CEA Codes forum

Dear mahendra2, TraceWin has a dual simulation engines: second-order moment envelope & non-linear macro-particle tracking. And depending on where you stand, the answers to your questions will be different. I'm going to reply considering that you're essentially talking about tracking. 1. You cannot, ...

TraceWin release 2.25.1.1

https://www.dacm-logiciels.fr/downloads

Dear Sir, Commands of type ERROR_XXX are only used to specify the range of errors. You also need to specify in the interface, on the ‘Errors’ -> ‘Error Setup’ page, which errors you want to apply and for how many runs you want to do. Then, you need to know whether you want to do just one run or stat...

Dear Abhishek, in the file ""partran1.out" for tracking or "tracewin1.out" for envelope results you can have the dispersion terms at each position of your simualtion File format is describe in the manuel see : https://dacm-codes.fr/Softwares/TraceWin_DOC/tracewin.htm#_Partran_and_Toutatis If you are...

Dear Pau

It is clear that the parallelization implemented in TraceWin was not at all designed to speed up the optimization phase, but to reduce the calculation time for very high numbers of particles, greater than 10e7.

Regards,

Didier

Dear Pau, Typically, during a tracking optimization, TraceWin will by default use 1000 particles and with this number going beyond 4 cores would be counter-productive in terms of efficiency (due to openMP). Now TraceWin can perfectly well be used in bath mode and there if your own optimisation algor...

TraceWin release 2.25.1.0

https://www.dacm-logiciels.fr/downloads

GenDTL release 6.3.0.3

https://www.dacm-logiciels.fr/downloads

GenLinWin release 3.1.0.5

https://www.dacm-logiciels.fr/downloads

TraceWin release 2.25.0.3

https://www.dacm-logiciels.fr/downloads