Page 1 of 1
ADJUST_DPHASE
Posted: Tue 2 Mar 2021 05:30
by wtam
Hi Colleagues,
What are the commands:
adjust_dphase
adjust_dfield
They only appear once on p87 of the user's manual.
Best regards,
Wai-Ming
Re: ADJUST_DPHASE
Posted: Tue 2 Mar 2021 11:00
by Didier
Dear Wai-Ming,
As it's explained in manual, both command was replaced by "ADJUST n -v ....". But whatever their role remains the same.
They allow to adjust the field and the phase of a cavity seen by the beam representing the machine with errors. In the simulations 2 beams are always transported, a first one in the perfect machine and a second one in the machine with errors (typically field and phase errors). These commands allow to adjust these field and phase errors. This is used in very specific simulations.
Regards,
Didier
Re: ADJUST_DPHASE
Posted: Tue 2 Mar 2021 16:11
by wtam
Dear Didier,
Thank you. I will keep that in mind for future reference.
Best regards,
Wai-Ming