Bug: Energy/Phase Limit + Envelope plots
Posted: Fri 19 Mar 2021 18:01
Dear Didier,
I think I found a bug in the newest TraceWin Version (2.16.6.13).
If I set Phase and Energy limits under "Multiparticle"->"Partran Energy and Phase limits ..."->"Particle is lost if:", the multiparticle envelope plots seem to be broken.
After encountering this in a project file, I tested on 2 PCs with a simple example file. An older Version did not show this behaviour (tested 2.16.6.6).
Normal behaviour without limits:
Broken with limits:
Best regards,
Hendrik
I think I found a bug in the newest TraceWin Version (2.16.6.13).
If I set Phase and Energy limits under "Multiparticle"->"Partran Energy and Phase limits ..."->"Particle is lost if:", the multiparticle envelope plots seem to be broken.
After encountering this in a project file, I tested on 2 PCs with a simple example file. An older Version did not show this behaviour (tested 2.16.6.6).
Normal behaviour without limits:
- working_no_wp_limits.png (62.17 KiB) Viewed 1510 times
- bug_wp_limits_set.png (61.12 KiB) Viewed 1510 times
Best regards,
Hendrik