adjust values on project .dat file in calculation directory
Posted: Thu 3 Apr 2025 14:59
Dear Didier,
I've seen that the project .dat file in the calculation directory report the values coming from the envelope matching also when
has been used the partran macthing.
Is this a correct behaviour of the Tracewin program ?
In the attached example, I was aspetting 8323.34 V in the test_t1.dat inside the calc directory, instead I get 8332.45 V, like the evelope matching result.
Best Regards,
Michele Comunian
I've seen that the project .dat file in the calculation directory report the values coming from the envelope matching also when
has been used the partran macthing.
Is this a correct behaviour of the Tracewin program ?
In the attached example, I was aspetting 8323.34 V in the test_t1.dat inside the calc directory, instead I get 8332.45 V, like the evelope matching result.
Best Regards,
Michele Comunian