Beam current element - error in version 2.17.1.6
Posted: Wed 2 Jun 2021 18:26
Dear Didier,
In the latest version of TraceWin I experienced a problem with the beam current element/command.
No matter what value I specify for the beam current I always get beam current of zero in the Beam current plot.
If I do not use the command then everything is plotted correctly.
In version 2.16.6.1 I did not experience this problem.
Thank you in advance.
Best regards,
Emil
In the latest version of TraceWin I experienced a problem with the beam current element/command.
No matter what value I specify for the beam current I always get beam current of zero in the Beam current plot.
If I do not use the command then everything is plotted correctly.
In version 2.16.6.1 I did not experience this problem.
Thank you in advance.
Best regards,
Emil