CEA Codes forum

Dear Didier,

Could you please provide an example of how to use DIAG_DCURRENT?
I would like to optimize a section such that there is no current/beam loss. According to my understanding to the description of DIAG_DCURRENT, I came up with the below, but didn't work:

DIAG_DCURRENT 22 0
xxx
ADJUST 22 1
xxx
xxx
DIAG_DCURRENT 22 0

Best regards,
Wai-Ming

Dear Wai-Ming,

Yes, this is the right method, but it obviously works when you are in Tracking mode, so don't forget to check in the "Matching" page -> "Match using diag" and "With partran" options.

Regards,

Didire