Dipole and edge angle and radius changed
Posted: Tue 9 Nov 2021 10:30
Dear Didier,
I have a very simple line with some steerers a triplet and a dipole.
The input line is with a edge radius of 1900 mm and a dipole bending angle of 45 deg.
i.e.:
EDGE 11.701 1900 40 0.45 2.8 20 0
BEND 45 1900 0 20 0
EDGE 11.701 1900 40 0.45 2.8 20 0
After a steerers and quads matching in envelope mode I get in the .dat file on calc dir:
EDGE 11.701 1888.4 40 0.45 2.8 20 0
BEND 45.2289 1888.4 0 20 0
EDGE 11.701 1888.4 40 0.45 2.8 20 0
So is change the dipole angle and the edge and dipole radius from 1900 to 1888.4 mm.
This change is also reported on data tab.
I attach the project files.
May you know why?
Best Regards,
Michele Comunian
I have a very simple line with some steerers a triplet and a dipole.
The input line is with a edge radius of 1900 mm and a dipole bending angle of 45 deg.
i.e.:
EDGE 11.701 1900 40 0.45 2.8 20 0
BEND 45 1900 0 20 0
EDGE 11.701 1900 40 0.45 2.8 20 0
After a steerers and quads matching in envelope mode I get in the .dat file on calc dir:
EDGE 11.701 1888.4 40 0.45 2.8 20 0
BEND 45.2289 1888.4 0 20 0
EDGE 11.701 1888.4 40 0.45 2.8 20 0
So is change the dipole angle and the edge and dipole radius from 1900 to 1888.4 mm.
This change is also reported on data tab.
I attach the project files.
May you know why?
Best Regards,
Michele Comunian