CEA Codes forum

Dear Didier,
For the command of 'ERROR_CAV_NCPL_STAT N r(0 /±1/2/±3/4/5), dx(mm), dy(mm), φx(°), φy(°), E(%), φ(°), dz(mm), Nb', the longitudinal shift dz exits, but in the 'errors setup ', the 'Z displacement' can not be selected. In the simulation results, the influence of dz is not included ?

Best,
Shuhui Liu

Dear Shuhui,

Yes, this option is not active and in fact would not be of much interest anyway because it has very little impact.

Regards,

Didier

Hi Didier,

What if the element is a dipole? Especially in field map format.

Kinds,
shliu

Dear Shuhui,

I never really thought about the dipole case, but roughly speaking I don't really see a big impact of having a dipole placed for example 100 μm ahead or behind.

Regards,

Didier