DIAG_DCURRENT  [SOLVED]

https://www.dacm-logiciels.fr/tracewin
Post Reply
United States of Americawtam
Skilled
Skilled
Posts: 101
Joined: Mon 7 Dec 2020 06:17
Location: Boston
Country:
United States of America (us)
United States of America

DIAG_DCURRENT

Post by United States of Americawtam »

Dear Didier,

What is the usage of DIAG_DCURRENT? It does not work as I expected. Please see attached project. I expected the optimization will increase the solenoid strength until transmission is 100%. Thank you.

Best regards,
Wai-Ming
Attachments
dcurrent.dat
(178 Bytes) Downloaded 70 times
dcurrent.ini
(43.77 KiB) Downloaded 66 times
User avatar
FranceDidier
Administrator
Administrator
Posts: 852
Joined: Wed 26 Aug 2020 14:40
Country:
France (fr)
France

Re: DIAG_DCURRENT  [SOLVED]

Post by FranceDidier »

Dear Wai-Ming,

I have attached your project with the correct options. Most of the necessary ones were not even selected. Honestly, using the mauel or the examples given on the matching topic, you could have put it in.
Also very important for this type of transmission optimization, I increased the number of particles to 100.000 because otherwise the transmission accuracy is too low to allow the alogrithm to converge correctly.

Regards,

Didier

Translated with www.DeepL.com/Translator (free version)
matching_options.png
matching_options.png (36.92 KiB) Viewed 2608 times
dcurrent.ini
(43.77 KiB) Downloaded 57 times
United States of Americawtam
Skilled
Skilled
Posts: 101
Joined: Mon 7 Dec 2020 06:17
Location: Boston
Country:
United States of America (us)
United States of America

Re: DIAG_DCURRENT

Post by United States of Americawtam »

Dear Didier,

Thank you.
It was a careless mistake I had. I started the project new and the "Maximum number of iterations" was defaulted to "0". I overlooked it.

Best regards,
Wai-Ming
Post Reply