CEA Codes forum

Dear Didier:

I have a question about using acceptance reduction in GenlinWin.
I set the const longitudinal acceptance at 80%. I think the acceptance will be reduced gradually over 10 periods. However, at the second period, the acceptance is reduced to 80% of the initial one by abruptly improving the synchronous phase. I don't know why. The accelerator consists of 13 periods, and each period contains two spoke cavities.

Thank you

Regards,
Emily

Dear Emily,

I will look into your problem, but could you put your project file here, which will help me to be sure that I am in your exact setting.

Regards,

Didier

Dear Emily,

Finally I found the problem, it is fixed, please update your code

Regards,

Didier

Dear Didier:
Thank you! The problem was solved.
At first,I upgraded the software, but the problem wasn't solved. Then I re-downloaded the software again and deleted the old version, and it finally worked.

Regards,
Emily