CEA Codes forum

Dear Wai-Ming,

I made some tests with "w_p_limit 0 10" & "w_p_limit 0 20" and the results following seems good!

Regards,

Didier

Dear Wai-Ming, I'll think about it, but it might be a big development that I'm not sure I'm up to at the moment. That said, you can always use chart_envelope in ‘partran’ mode using the dtl1.plt file via the PlotWin tool. This is heavier and slower because it is not based on a denity file but on the...

Dear Wai-Ming,

Moving a diagnosis to a field map is only possible because it does not influence the beam optics. It is therefore totally impossible to propose the same thing for other elements escept for steering because its quite simple to manage.

Regards,

Didier

Dear Wai-Ming,

It's done.

Regards,

Didier

TraceWin release 2.24.3.4

https://www.dacm-logiciels.fr/downloads

Dear Pedro, CHOPPER is not an element but a command, so there's no way to adjust these parameters, except for the length of the elements to which this command applies, i.e. drifts if you've placed this command in front of drifts. The only solution here is to create your own elements (see the manual ...

Dear Emmanuel, In your first file, I just replaced Δp/p0 with ‘0’ to solve the problem (see attached file) [/attachment] As far as your second file is concerned, everything is wrong, both the header and the list of particles, so I don't really know how to correct it. Nothing seems to correspond to w...

Dear Pedro, Into the file "ENV_diag1.dat" (envelope results) or "PAR_diag1.dat" (tracking resuluts), you can find all beam parameters needed reached at each position of diagnostics elements. If you want to change step of ADJUST command, have a look on the manuel about this command, some parameters a...

Dear Pedro,

Normally, at the end of the matching processes, the two files contain the corresponding results, so I don't really understand your request.

Regards,

Didier

Dear Shliu,

It's fixed, but please check, as I found an error, but not exactly the one you mentioned.

Regards,

Didier