Multiparticle Envelopes Plots

https://www.dacm-logiciels.fr/tracewin
Post Reply
Italycomunian
Initiated
Initiated
Posts: 52
Joined: Mon 30 Nov 2020 09:50
Location: Legnaro National Laboratories
Country:
Italy (it) Italy
Contact:
Contact comunian

Multiparticle Envelopes Plots

Post by Italycomunian »

Dear Didier,
I've done a linac design by using GenLinWin. What I've noted is that is reported by the envelopes plots a not correct sequence of elements, i.e. in the attached envelope.png the yellow box should be reported only two times, because I'm using two cavities. Instead the FM1 and FM2 maps are reported correctly.
May you handle that?
I've attached also the whole tracewin project.
Best Regards,
Michele Comunian
envelope.png
envelope.png (182.79 KiB) Viewed 176 times
Attachments
Cavity_Field_Sect_3.edz
(188 Bytes) Downloaded 22 times
Cavity_Field_Sect_2.edz
(216 Bytes) Downloaded 20 times
Cavity_Field_Sect_1.edz
(308 Bytes) Downloaded 26 times
Cavity_Field_Sect_4.edz
(196 Bytes) Downloaded 26 times
prova13_4fam10MV.cal
(140 Bytes) Downloaded 32 times
prova13_4fam10MV.dat
(13.31 KiB) Downloaded 33 times
prova13_4fam10MV.ini
(43.77 KiB) Downloaded 20 times
Top
User avatar
FranceDidier
Administrator
Administrator
Posts: 1245
Joined: Wed 26 Aug 2020 14:40
Country:
France (fr) France

Re: Multiparticle Envelopes Plots

Post by FranceDidier »

Dear Michele,

I was sure I’d replied to you, but now I’m not so sure.
Anyway, never mind and sorry for the delay.
The yellow box indicates the number of gaps in your cavity. Here there are 2, so, 4, because you have two cavities side by side

Regards,

Didier
Top
Post Reply

Return to “TraceWin”