Dear Didier,
I have a very simple line with some steerers a triplet and a dipole.
The input line is with a edge radius of 1900 mm and a dipole bending angle of 45 deg.
i.e.:
EDGE 11.701 1900 40 0.45 2.8 20 0
BEND 45 1900 0 20 0
EDGE 11.701 1900 40 0.45 2.8 20 0
After a steerers and quads matching in envelope mode I get in the .dat file on calc dir:
EDGE 11.701 1888.4 40 0.45 2.8 20 0
BEND 45.2289 1888.4 0 20 0
EDGE 11.701 1888.4 40 0.45 2.8 20 0
So is change the dipole angle and the edge and dipole radius from 1900 to 1888.4 mm.
This change is also reported on data tab.
I attach the project files.
May you know why?
Best Regards,
Michele Comunian
Dipole and edge angle and radius changed
-
comunian - Initiated
- Posts: 41
- Joined: Mon 30 Nov 2020 09:50
- Location: Legnaro National Laboratories
- Country:
Italy (it)
- Contact:
Dipole and edge angle and radius changed
- Attachments
-
- test_dipole.ini
- (43.77 KiB) Downloaded 182 times
-
- test_dipole.dat
- (1.05 KiB) Downloaded 185 times
