Automatic 'Save table to file' via noGUI

https://www.dacm-logiciels.fr/tracewin
Post Reply
Belgiumjarnovandewalle
Neophyte
Neophyte
Posts: 12
Joined: Mon 30 May 2022 22:23
Country:
Belgium (be)
Belgium

Automatic 'Save table to file' via noGUI

Post by Belgiumjarnovandewalle »

Hello Didier,

Is there a possibility to automatically perform the action 'Save table to file' (which one can perform manually in the Data tab of the GUI) when executing TRACEWIN with the 'noGUI' version (TraceWin_noGUI.exe) from the command prompt ?

A bit similar to the flag 'Synoptic_file'.
In the manual there is a mention of the parameter 'tab_file' (p. 16), but it mentions at the same time that this only applies to the GUI version. Which is strange, since it's a parameter to pass on to the 'noGUI' executable ? In any case, when trying it with the command tab_file=test.dat passed on to TraceWin_noGUI.exe, it doesn't generate the test.dat file.

Would it be also possible to generate the output of 'Save table to file' in any case (also when executing via GUI) in the calculation directory ? It's format is ideally suited for post-processing ... but now there is always a manual intervention needed ...

Thanks in advance and kind regards
Jarno
User avatar
FranceDidier
Administrator
Administrator
Posts: 982
Joined: Wed 26 Aug 2020 14:40
Country:
France (fr)
France

Re: Automatic 'Save table to file' via noGUI

Post by FranceDidier »

Dear Jarno,

Ok it's done and available in the new version

Regards,

Didier
Post Reply