PLOT_DST limit error

https://www.dacm-logiciels.fr/tracewin
Post Reply
Franceemo
Neophyte
Neophyte
Posts: 16
Joined: Mon 30 Nov 2020 09:52
Country:
France (fr)
France

PLOT_DST limit error

Post by Franceemo »

Dear Didier,

Lately I get this error message sometimes during PARTRAN optimizations.

PLOT_DST number limited to 500
From->[PARTRAN] Library
From->[PROCESS_ENVELOPE] : Run PARTRAN
From->[PROCESS_ENVELOPE] : Run multiparticle program


It happens only sometimes and I cannot find the reason.
Once it has happened, I cannot continue with the optimization until I restart TraceWin.
It happened at step #250 although the limit of iterations was set to 500 for multiparticle in the 'Matching' tab.

Thank you in advance for your assistance.
Attachments
Total criteria.png
Total criteria.png (6.48 KiB) Viewed 2406 times
PLOT_DST error.png
PLOT_DST error.png (33.57 KiB) Viewed 2406 times
User avatar
FranceDidier
Administrator
Administrator
Posts: 982
Joined: Wed 26 Aug 2020 14:40
Country:
France (fr)
France

Re: PLOT_DST limit error

Post by FranceDidier »

Dear Emo,

I think I've found the problem, but I'm not sure because I don't know exactly what you are doing. Before I put a new corrected version online, I would like to see your project if it is possible for you. Could you post your project files, *.dat and *.ini

Regards,

Didier
Franceemo
Neophyte
Neophyte
Posts: 16
Joined: Mon 30 Nov 2020 09:52
Country:
France (fr)
France

Re: PLOT_DST limit error

Post by Franceemo »

Dear Didier,

Thank you for the fast reply.
Apparently two of my collaborators experienced similar problems.

Here are the .ini and .dat files.
I am afraid I made some changes in the TraceWin settings after the error showed.
I hope it will not make it difficult to find the source.

Thank you in advance.

Best regards,
Emil
MEBT3 section_v01b.ini
(30.88 KiB) Downloaded 219 times
mebt3 section_v01b.dat
(14.93 KiB) Downloaded 199 times
User avatar
FranceDidier
Administrator
Administrator
Posts: 982
Joined: Wed 26 Aug 2020 14:40
Country:
France (fr)
France

Re: PLOT_DST limit error

Post by FranceDidier »

Dear Emo,

Thank for your project files.
Ok, problem is now fixed in the new TraceWin version available. So please upgrade your code.

Regards,

Didier
Post Reply