PLOT_DST limit error

[emo]

Dear Didier,

Lately I get this error message sometimes during PARTRAN optimizations.

PLOT_DST number limited to 500
From->[PARTRAN] Library
From->[PROCESS_ENVELOPE] : Run PARTRAN
From->[PROCESS_ENVELOPE] : Run multiparticle program

It happens only sometimes and I cannot find the reason.
Once it has happened, I cannot continue with the optimization until I restart TraceWin.
It happened at step #250 although the limit of iterations was set to 500 for multiparticle in the 'Matching' tab.

Thank you in advance for your assistance.

[Didier]

Dear Emo,

I think I've found the problem, but I'm not sure because I don't know exactly what you are doing. Before I put a new corrected version online, I would like to see your project if it is possible for you. Could you post your project files, *.dat and *.ini

Regards,

Didier

[emo]

Dear Didier,

Thank you for the fast reply.
Apparently two of my collaborators experienced similar problems.

Here are the .ini and .dat files.
I am afraid I made some changes in the TraceWin settings after the error showed.
I hope it will not make it difficult to find the source.

Thank you in advance.

Best regards,
Emil

MEBT3 section_v01b.ini

(30.88 KiB) Downloaded 219 times

mebt3 section_v01b.dat

(14.93 KiB) Downloaded 199 times

[Didier]

Dear Emo,

Thank for your project files.
Ok, problem is now fixed in the new TraceWin version available. So please upgrade your code.

Regards,

Didier