Dear Didier,
is it possible to introduce on TraceWin the value of the magnetic field used for the bending magnet element?
I mean to have the possibility to fix the value of the magnetic field B used in the simulation, independently from the Brho of the beam.
Best Regards,
Michele Comunian
set B value for Bending Magnet
Re: set B value for Bending Magnet
Dear Michele,
I find it complicated to do that, as it would mean that the trajectory would no longer be on the axis and so the matrix used for the dipole would no longer be relevant. In my opinion, this is a totally different development. That said, the magnetic field corresponding to the bro is indicated on the envelope plot and we can also introduce a few percent error on this field via the errors.
But perhaps I haven't understood your need
Regards,
Didier
I find it complicated to do that, as it would mean that the trajectory would no longer be on the axis and so the matrix used for the dipole would no longer be relevant. In my opinion, this is a totally different development. That said, the magnetic field corresponding to the bro is indicated on the envelope plot and we can also introduce a few percent error on this field via the errors.
But perhaps I haven't understood your need
Regards,
Didier