in the attached tracewin project, a long RFQ, is not working the option to calculate the input matched beam with Partran.
Best Regards,
Michele Comunian
- No_match_partran.PNG (16.54 KiB) Viewed 1824 times
RFQ Matching with partran/toutatis
-
comunian - Initiated
- Posts: 41
- Joined: Mon 30 Nov 2020 09:50
- Location: Legnaro National Laboratories
- Country:
Italy (it)
- Contact:
RFQ Matching with partran/toutatis
Dear Didier,
in the attached tracewin project, a long RFQ, is not working the option to calculate the input matched beam with Partran.
Best Regards,
Michele Comunian
in the attached tracewin project, a long RFQ, is not working the option to calculate the input matched beam with Partran.
Best Regards,
Michele Comunian
- Attachments
-
- rfq200_nom.ini
- (43.77 KiB) Downloaded 142 times
-
- rfq200_nom.dat
- (34.79 KiB) Downloaded 129 times
-
- rfq200_nom.cal
- (275 Bytes) Downloaded 183 times
Re: RFQ Matching with partran/toutatis
Dear Michele,
Toutatis is not able to simulate too short RFQ, it's why matching of RFQ imposes to define a number of lattice greater than 6 for simulation, like following picture
Regards,
Didier
Toutatis is not able to simulate too short RFQ, it's why matching of RFQ imposes to define a number of lattice greater than 6 for simulation, like following picture
- matching.png (50.92 KiB) Viewed 1818 times
Didier
-
comunian
- Initiated
- Posts: 41
- Joined: Mon 30 Nov 2020 09:50
- Location: Legnaro National Laboratories
- Country:
Italy (it) - Contact:
Re: RFQ Matching with partran/toutatis
Dear Didier,
with the phase advance put to 10 now works!
Best Regards.
Michele comunian
with the phase advance put to 10 now works!
Best Regards.
Michele comunian