Diagnostic in same position warning [SOLVED]

[yngvelevinsen]

Hi,

I just got a warning about diagnostic being in same position. I suppose this is a configuration issue on our part, but I was thinking it would be useful to see e.g. the diagnostic id number in the error message to make it easier for the user to find and fix maybe?

I can also add that I produced the error because I had cut our lattice and there was no BPM after the last cavities which had a TUNE_CAVITY in front. So the more precise error message I think would be to say that there is no downstream BPM in this particular case.

[Didier]

Dear Yngve,

As usual you are perfectly right this message is really not usable. An improvement is proposed in the latest version of TraceWin.

Regards,

Didier

[yngvelevinsen]

Thank you Didier, just tested the updated error message and now it is easier to understand